Roundness measuring machine

Taylor Hobson Talyrond 265

PRICE REDUCED AGAIN!!!!!

Taylor Hobson Talyrond 265 roundness measuring system.
Extremely accurate; it can measure the roundness of lenses, optics, pistons, turbine components, tubes, shafts, and also eccentricity, e.g., of cams on a camshaft or journals of a crankshaft. This would certainly be of interest to motorsport and tuning companies.

The first photo is a "representative image" from a Taylor Hobson catalog, showing how it is set up, except for the computer, which is a newer, smaller-form-factor HP model.

Max. diameter: 350mm
Kdjdpfx Aozcqy Eohhsr
Max. test piece height: 500mm (higher measurements are possible, up to a maximum of 1000mm when measured in two halves...)
Self-centering of the workpiece: +/- 5mm
Max. weight of test piece: 40 kg

The system has been used very little and has had only two owners. The first owner, from whom I purchased it, was an implant company in Hamburg. It was used in a "medically clean environment" and is extremely clean. It was never located in a dirty machine hall.
The year of manufacture is estimated to be between 2002 and 2005.
The Taylor-Hobson measuring software is, of course, included and runs on the supplied HP computer (without a password...).
Accessories are included: the original Taylor-Hobson desk, computer, monitor, seven (7!) measuring probes, each of which is very expensive to purchase. There is also a sample/sample lens (hemisphere) for calibration! The very detailed operating manual is on the USB stick, and it also contains all the circuit diagrams and functional diagrams!

The system will be shipped on two Euro pallets using a freight carrier. It is already securely fastened to the pallets. The Talyrond 265 and the desk will be well-protected with bubble wrap, etc., and secured with stretch film for transport. The system itself is fixed with "transport safety screws."

Shipping costs within Germany are included; I will cover them!
So, within Germany: FREE SHIPPING!

The measuring system should definitely be assembled and put into operation by a Taylor Hobson service technician, who can then also recalibrate the system on-site. This is now recommended after a few years. Mistakes can be made during assembly and commissioning. For example, some locking screws are installed for transport; if you forget to remove them, the system could be damaged when it starts up.

A truly well-maintained, very accurate system that will provide excellent service for many years to come!!

The listing was translated automatically. Translation errors are possible.